Advertisement
Dakota / Kansas / Inver / Copenhagen
Model: DKT20 / KNS20 / INV20 / COP20
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Important Safety Advice
When using electrical appliances, basic
precautions should always be followed to
reduce the risk of fire, electrical shock and
injury to persons, including the following:
If the appliance is damaged, check with the
supplier before installation and operation.
Do not use outdoors.
Do not use in the immediate surroundings of
a bath, shower or swimming pool.
Do not locate the appliance immediately
below a fixed socket outlet or connection
box.
The appliance carries the Warning symbol
DO NOT COVER, indicating that it must not
be covered.
This appliance can be used by children
aged form 8 years and above and
persons with reduced physical, sensory or
mental capabilities or lack of experience
and knowledge if they have been given
supervision or instruction concerning use of
the appliance in a safe way and understand
the hazards involved. Children shall not
play with the appliance. Cleaning and user
maintenance shall not be made by Children
without supervision.
Children of less than 3 years should be
kept away unless continuously supervised.
Children aged from 3 years and less than 8
years shall only switch on/off the appliance
provided that it has been placed or installed
in its intended normal operating position
and they have been given supervision or
instruction concerning use of the appliance
in a safe way and understanding the hazards
involved. Children aged from 3 years and
less than 8 years shall not plug in, regulate
and clean the appliance or perform user
maintenance.
Do not use this appliance in series with a
thermal control, a program controller, a timer
or any other device that switches on the heat
automatically, since a fire risk exists when
the appliance is accidentally covered or
displaced.
Ensure that furniture, curtains or other
combustible material are positioned no
closer than 1 metre from the appliance.
In the event of a fault unplug the appliance.
Unplug the appliance when not required for
long periods.
Although this appliance complies with safety
standards, we do not recommend its use
on deep pile carpets or on long hair type of
rugs.
The appliance must be positioned so that the
plug is accessible.
If the supply cord is damaged it must be
replaced by the manufacturer or service
agent or a similarly qualified person in order
to avoid a hazard.
Keep the supply cord away from the front of
the appliance.
Warning: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through
an external switching device, such as a timer,
or connected to a circuit that is regularly
switched on and off by the utility.
CAUTION - Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and
vulnerable people are present.
The heater carries the Warning symbol,
indicating that it must not be covered.
This instruction can be found at
WWW.DIMPLEX.CO.UK
Technical Information
Model No: DKT20, DKT20BL, KNS20,KNS20BL, INV20, COP20
Heat Output
Nominal Heat Output
Minimum Heat Output
Maximum Continous Heat Output P
Auxiliary Electricity Consumption
In Standby mode
With mechanic thermostat room temperature control.
General
Unpack the heater carefully and retain the packaging for possible
future use, in the event of moving or returning the fire to your supplier.
Loose coals/pebbles are packed separately within the carton. When
the heater is assembled the coals/pebbles are placed on top of the
fuel bed
The fire incorporates a flame effect, which can be used with or
without heating, so that the comforting effect may be enjoyed at any
time of the year. Using the flame effect on its own only requires little
electricity.
Before connecting the heater check that the supply voltage is the same
as that stated on the heater.
Please note: Used in an environment where background noise is very
low, it may be possible to hear a sound which is related to the operation
of the flame effect. This is normal and should not be a cause for concern.
Electrical connection
WARNING – THIS APPLIANCE MUST BE EARTHED
This heater must be used on an AC ~ supply only and the voltage
marked on the heater must correspond to the supply voltage.
Before switching on, please read the safety warnings and operating
instructions.
In the event of replacing the fuse in the plug supplied, a 13 amp fuse
approved by ASTA to BS1362 must be used.
UK
230V
240V
P
1.7
-
1.9
kW
Nom
P
0.9
-
1.0
kW
min
1.7
-
1.9
kW
max,c
el
0.02
-
0.02
W
SB
Advertisement
