Controls - GE Profile ENERGY STAR PHC06 Series Owner's Manual

Controls

Features and appearance will vary.
This section explains how to operate this air conditioner.
IMPORTANT:
When you turn off the air conditioner, either at the control
panel or with the remote control, wait at least 3 minutes
before turning it back on. This prevents the compressor
from overloading. This 3 minute delay also applies when
switching from cool mode to fan and back.
NOTE: There is a built in 3 minute delay. You may notice
the compressor might not start right away. This was
designated to protect the unit.
Do not operate your air conditioner in the Cool Mode when
the outside temperature is below 61° F (16° C). This inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
Controls
1. MODE
1. Press MODE until you see the indicator light come on
next to the desired setting.
2. Choose Fan, Cool, Energy save (E-Save), or Dehum.
Fan - Only the fan runs. Press FAN SPEED to select
High, Med or Quiet fan speed. The display shows the
current room temperature.
NOTE: in fan mode, the temperature cannot be set.
E-Save - In this this mode the fan runs only when
cooling is needed. The fan will run for 3 minutes after
the compressor shuts off. The fan then cycles on for 2
minutes at 10 minute intervals until the temperature in
the room is above the set temperature. The compressor
then turns back on.
Cool - Cools the room. Press FAN SPEED to select
High, Med, Quiet or Auto Cool fan speed. Press
+
the TEMP/TIME
temperature. The fan will run continuously in cool mode.
Dehum - Aids in removing humidity from the room.
Dehum mode cannot be used to cool room.
NOTE: In Dehum mode, when the set temperature is
close to ambient temperature, the compressor may stop
and the fan will run in Quiet speed only.
4
Power
Delay
3
–
or arrow button to adjust the
Auto High Med Quiet
Fan
Temp | Time
2
4
NOTE: When the air conditioner is first plugged in, the
LED display will show "88" for 3 seconds. After the air
conditioner is turned on for the first time, the display will
show the temperature 72° F and the fan will automatically
set the Quiet speed and the Mode indicator will show
ENERGY SAVE.
NOTE: To switch the temperature display between
Fahrenheit (°F) and Celsius (°C), the air conditioner must
be plugged in and turned on. On the control panel on the
at the same time and hold for 3 seconds. Press F/C button
on remote control to switch between Fahrenheit (°F) and
Celsius (°C).
NOTE: Each time this ENERGY STAR qualified air
conditioner is turned on, it will operate in energy save mode
per the EPA requirements. You can select any other mode
to satisfy your needs.
2. FAN SPEED
1. Press FAN SPEED until you see the indicator light
come on next to the desired setting.
2. Choose High, Med, Quiet, or Auto.
HIGH – For maximum cooling.
MED – For normal cooling.
ideal cooling based on the room temperature.
Cool Fan
E-Save Dehum
Mode Filter Wi
1 5 6
Solid light indicates WiFi connected.
Blinking light indicates connecting
See WiFi Setup section in this manual (pg. 15)
49-5000295 Rev. 1