Walker S14i Operator's Manual page 56

Maintenance Instructions
Ident
No. Location
1 Deck Caster Wheel Fork Pivot
2 Blade Spindle
3 Pivot Assembly, Tilt-Up Deck
4 Deck Support Arm Socket
5 Universal Joint Shaft Assembly
6 Tee Gearbox, Deck
7 Blade Drive Gearbox
8 FSC Lever Pivot
9 Steering Lever Pivot
10 Deck-to-PTO Coupling
(Grease Spline Slide Area)
11 Universal Joint Tube Assembly
12 Deck Support Arm Pivot
13 Hydro Idler Pivot
14 PTO Clutch Lever Pivot
15 Body Latch Pivot
16 Transaxle Oil Reservoir
17 Clutch Actuator Push Rod
18 PTO Belt Tightener Pivot
Lubrication Points for Optional Belt Driven Decks (DS42 Belt Drive Shown)
52
Lubrication No.
Type Places
Grease 2
Δ
Grease 2
Grease 4
Grease 2
**
Grease 1
Oil* 1
Oil* 2
Grease 1
Grease 2
Grease 1
Grease** 1
Grease 2
Grease 1
Grease 1
Oil 1
Oil/20W-50 1
Grease 1
Grease 1
1
2
3 4
Ident
No. Location
19 Brake Band Pivot Pins (Clevis)
20 Catcher Hinge Point
21 Throttle Control Cable Ends
22 Engine Dipstick / Oil Fill
23 Engine Idler Pivot
24 Parking Brake Clevis
25 Parking Brake Lever
26 Throttle Control Pivot
*
Gearboxes are permanently lubricated and sealed re-
quiring no scheduled lubrication. Oil level should be
checked only when an oil leak is noted. Refer to Mower
Deck Gearbox Lubrication in this section.
**
Grease every twenty-five (25) hours. Refer to PTO U-
Joint Lubrication (Tractor) in this section for Lubricat-
ing U-Joint on tractor.
***
Refer to Engine Oil located on page 50.
Δ
Belt Driven Decks Only
NOTE: DS42 Belt Drive and DC36R Tilt-Up Decks are shown for
reference. For other Deck Lubrication Points, Refer to
Deck and Carrier Frame Illustrated Parts Manual.
1
5 4 3
LUBRICATION
Lubrication No.
Type Places
Oil 2
Oil 2
Oil 2
Oil*** 1
Grease 1
Oil 2
Grease 1
Oil 1
2