Walker S14i Operator's Manual page 17

Safety Instructions - Operating
14. The maximum recommended slope operat-
ing angle is 15 degrees or 27% grade. When
operating the machine on a slope, reduce speed
and use caution to start, stop, and maneuver.
To prevent tipping or loss of control of the ma­
chine, avoid sharp turns or sudden changes in
direction. Do not operate the machine on a
slope greater than 15 degrees.
15. Never adjust cutting height with the engine
running. Before adjusting cutting height or
servicing, disengage the blade clutch (PTO),
engage parking brake, stop the engine, and re­
move the ignition key. Wait for all movement to
stop before getting off the seat.
NOTE: A blade/blower brake should normally
stop drive line rotation within five (5) seconds of
disengaging the PTO clutch.
16. For side discharge mower decks, do not oper-
ate with the grass deflector shield removed.
Keep the deflector in the lowest possible posi­
tion.
17. When using the tilt-up deck, observe the fol-
lowing:
a. Do not move tractor with deck in tilt-up
position.
b. Never tilt body forward with deck in tilt-up
position.
18. Do not operate the machine with the grass
catcher in the DUMP position or with the
back door OPEN. Dangerous projectiles may
be thrown out of the discharge chute or the back
of the grass catcher.
19. Use care when closing the grass catcher
door. Keep fingers and hands away from the
hinge and pinch points when the door is being
closed. Also, keep fingers and hands clear of
the door frame. The door may slam shut with
considerable force.
20. In case of a clogged or plugged mower deck
or GHS catching system:
a. Disengage the blade clutch (PTO), engage
the parking brake, and turn the engine off
before leaving the seat.
b. LOOK to make sure blade drive shaft and
blower drive pulley movement has stopped
before trying to unclog the system.
c. Disconnect the spark plug wire.
d. Never place hands under the deck or in the
GHS blower - use a stick or similar tool to
remove clogged material.
21. If the cutting blades strike a solid object or the
machine begins to vibrate abnormally, immedi-
ately disengage the blade clutch (PTO), en-
gage the parking brake, stop the engine,
and wait for all moving parts to stop. To pre­
vent accidental starting, disconnect the spark
plug wire. Thoroughly inspect the mower and
repair any damage before restarting the engine
and operating the mower. Make sure cutter
blades are in good condition and blade nuts are
·
torqued to 60 lb ft (81 N
decks, and blade bolts torqued to 70 lb
·
N m) for belt driven decks.
22. Do not touch the engine or muffler while the
engine is running or immediately after stop-
ping the engine. These areas may be hot
enough to cause serious burns.
23. When leaving the machine unattended, disen-
gage the blade clutch (PTO), engage the
parking brake, stop the engine, and remove
the key.
CAUTION
Use leg muscles and firm footing when lift-
ing the catcher to dump; avoid bending at
the waist and using back muscles in order
to prevent back injury.
·
m) for gear driven
·
ft (95
13