Hardi AutoHeight Instruction Book page 36

4 - System setup
Switch 2-8
For AutoHeight the recommended DIP switch settings are as illustrated.
With the switches set as illustrated all hydraulic functions will trigger
manual override with the exception of boom tilt and boom lift:
• Boom tilt (DIP 5) is switched off to allow tilt switch presses to be
received by the AutoHeight controller, allowing independent wing
override functionality.
If this switch is ON (closed) any manual boom tilt function will
trigger manual mode.
• Boom lift (DIP 7) is switched off because switch sensing is performed on the boom lift/lower switch. Manual override
will still occur after an extended switch press. A short switch press will not trigger manual mode; however when HM2
(or HW2) is used a short switch press is used to trigger headland mode.
If this switch is left ON any manual boom lift function will trigger manual mode. This switch must be OFF for HM2 (or
HW2) to function properly.
36