Tools Required; Product Disassembly Process - HP ProOne 600 G5 Disassembly Instructions

2.0 Tools Required

List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Description #1 Phillips screwdriver (for 12 PCS on bottom case )
Description #2 Phillips screwdriver (for 9 PCS on motherboard)
Description #3 Phillips screwdriver (for 2 PCS on HDD Bracket & 4 PCS on Battery)
Description #4 Phillips screwdriver (for 10 PCS on base side hinge bracket)
Description #5 Use jig disassembly Lcd Bezel with Lcd cover

3.0 Product Disassembly Process

3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. Release 4 Phillips #2 screws then remove roof cover by hands from top side refer figure 1
2. Release 2 Phillips #2 screws then push out ODD kits. refer figure 2
3. Check hood sensor cable would be remove from hook of FAN. refer figure 3
4. Release 3 T15 screws then remove FAN from system.
5. Release 4 T15 screws then remove heat sink refer figure 4
6. Unplug Power FFC, Speaker cable and CCD cable refer figure 5
7. Unplug LVDS FFC cable refer figure 6
8. Unplug Antenna cable, Back light cable, Hood sensor cable, HDD FFC cable, Touch cable., Touch cable. Don't unplug
RTC battery
9. Release 1 Phillips #1 screw then remove Wireless card refer figure 9
10. Move outward the latch on both side of the DIMM.Then take out DIMM refer figure 10
11. Release 3 T15 screws to take out MB refer figure 11
12. make the system turn the other side.Remove the speaker grill by hands refer figure 12
13. Release 4 T15 screws then remove speaker refer figure 13.
14. Remove Power holder with releasing 1 Phillips #1 screw refer figure 14.
15. Remove 2 antenna from plastic refer figure 15
16. Release 3 Phillips #1 screw then make system turn to other side refer figure 16
17. Remove webcam housing cover by hands refer figure 17
18. Release 2 Phillips screws then remove CCD bracket.Unplug the webcam cable.refer figure 18
19. Release 4 Phillips screws then take out the pop up webcam structure refer figure 19
20. Release 2 Phillips screws then remove CCD bracket. Unplug the webcam cable. refer figure 20
21. Release 4 Phillips #1 screws then remove basepan bracket. You will see LVDS and back light cable refer figure 21
22. Remove 6 Phillips #1 screws can make the LCD and panel frame to be separated refer figure 22
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
EL-MF877-00
Template Revision B
PSG instructions for this template are available at EL-MF877-01
Tool Size (if
applicable)
#1 2.5~3.0
kg-cm
#1 2.5~3.0
kg-cm
#1 2.5~3.0
kg-cm
#1 2.5~3.0
kg-cm
Pick
thickness
0.3~0.4mm
Page 2