Preparing For The Installation Of The Tv; Kd-77A9G - Sony SU-WL450 Installation Information

Preparing for the installation
of the TV
Refer to the Setup Guide for stand installation.

KD-77A9G

1
Mark the installation location on
the wall.
 Use masking tape, etc. (not supplied) to
mark the location of the TV near the
Base or Base Adaptor. Refer to the
following table.
Screen centre point
Length for
marking
Model Name
KD-77A9G 1,721 362
(1,000)
(300)
Masking tape
Unit: mm
Screen
centre
dimension
150 24
− 9 (GB) −
2
Remove the stand cover and
terminal covers.

3
Remove the screws from the
rear of the TV.
4
Attach the Attachment parts for
Wall-Mount Bracket. Check the
Attachment parts by referring to
"Supplied with SU-WL450" in
"Checking the parts" on page
5.
Note
 Firmly secure the Attachment parts using screws.
 When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
 Be sure to store the used or unused parts in a safe
place for future use. Retain this manual for future
reference.




GB