Sony MDR-XB950B1 Service Manual page 6

MDR-XB950B1
2-5. HOUSING (L) ASSY (L-ch)
Note: When attaching the housing (L) assy to
the hanger block, be sure to attach from
the side with the relay cable first.
2 Remove the shaft of hanger block
from the housing (L) assy.
2-6. FRONT PLATE (R) ASSY (DR2) (R-ch)
– –
2 Remove the front plate (R) assy
in the direction of the arrow.
6
hole
3 Draw the relay cable out of
the hole in housing (L) assy.
to front plate (R) assy (DR2)
Note 1: When installing the front plate (R) assy (DR2),
3 Remove the solder.
[natural]
3 Remove the solder.
[red]
driver
hanger block
1 Remove the shaft of hanger block
from the housing (L) assy.
4 housing (L) assy
– L-ch –
BATT board
filament tape
(sub material)
arrange the driver wire into this portion.
4 front plate (R) assy
(DR2)
1 two tapping screws (B2)
Note 2: Be careful not to let the
removed screws stick to
the magnet of the driver.
1 two tapping screws (B2)
Note 2: Be careful not to let the
removed screws stick to
the magnet of the driver.
[natural]
[red]