Sony MDR-XB950B1 Service Manual page 8

MDR-XB950B1
2-8. BATTERY ASSY (BAT1) (R-ch)
3 Peel off the battery adhesive sheet.
Note 1: The battery adhesive sheet is supplied
with the battery assy (BAT1).
If the battery adhesive sheet remains on
the housing (R) side after removing the
battery assy (BAT1), carefully peel off
the battery adhesive sheet and affix it to
the battery assy (BAT1).
– R-ch
2-9. HOUSING (R) ASSY (R-ch)
Note 1: The NFC board cannot replace with single. When replacing
the NFC board, be sure to replace the MAIN board simul-
taneously. (Repair parts are supplied together with parts that
include the MAIN board and NFC board)
Note 2: When attaching the housing (R) assy to
the hanger block, be sure to attach from
the side with the relay cable first.
1 Remove the shaft of hanger block
from the housing (R) assy.
8
battery assy (BAT1)
–
groove
4 battery assy (BAT1)
Note 2: When removing the battery assy (BAT1)
from the battery adhesive sheet, the battery
assy (BAT1) cannot be reused.
Be sure to replace them with new parts.
1 claw
2 cover battery assy
1 claw
hanger block
2 Remove the shaft of hanger block
from the housing (R) assy.
3 Draw the relay cable out of
the hole in housing (R) assy.
4 housing (R) assy
NFC board
– R-ch –