Huawei AR502 Series Quick Start Manual page 8

Scenario 1: Installing a Router in an IP65 Enclosure Assembly Box (Wall-mounted)
1
Attach the IP65 enclosure assembly box mounting bracket to the wall and keep its top and bottom edges
horizontal. Use a marker to mark four mounting positions, two at the top and two at the bottom.
1
2 Install the mounting bracket on the IP65 enclosure assembly box.
a.
Put the mounting bracket on the back of the IP65 enclosure assembly box. Adjust the position of the
mounting bracket to align the mounting holes on it with the four screw holes on the router.
b.
Use the four M5x10 screws to secure the mounting bracket to the IP65 enclosure assembly box.
3
Mount the IP65 enclosure assembly box on the wall.
a. Use the hammer drill to drill holes in the four mounting positions marked on the wall and install the
expansion tube. Use the Phillips screwdriver to install the four ST4.2 self-tapping screws in the marked
positions on the wall. Leave 2 mm of the screws out of the wall.
b. Keep the interface down and hang the mounting bracket on the four ST4.2 self-tapping screws.
c. Use the Phillips screwdriver to tighten the two ST4.2 self-tapping screws in the upper mounting holes
and then tighten the two ST4.2 self-tapping screws in the lower mounting holes.
Scenario 2: Installing a Router in an IP65 Enclosure Assembly Box (Pole-mounted)
1
Pass the two hose clamps through the holes on the pole-mounted mounting bracket of the IP65 enclosure
assembly box.
2
a
b
3
2mm
7
C