Huawei AR502 Series Quick Start Manual page 5

Scenario 2: Mounting the Router on a Wall
CAUTION
Before drilling holes on a wall, make sure there are no power cables in the wall to avoid electric shock.
Take water-proofing measures to protect a wall-mounted router from damages caused by water.
Screws must be installed solid in the wall; otherwise, the wall-mounted router may fall down after cables are
connected.
Ensure that there are no flammable or explosive materials near the router and no obstructions within 100 mm
around the router.
1
Use a measuring tape to determine the two mounting bracket installation positions. Keep the two
positions on a horizontal line and mark the positions with a marker.
NOTE
The center distance between the two mounting holes
for the mounting bracket is 74 mm.
2
Use a Phillips screwdriver to fix the mounting bracket on the rear of the router with four countersunk
M3x6 screws.
NOTE Before install the mounting bracket on an AR502CG-L
router, remove the DIN mounting kit at the back of the
router.
3 Use the Phillips screwdriver to install two M4x8 pan
head screws in the marked positions on the wall,
and leave 2 mm of the screws out of the wall.
4
Hang the router on the M4x8 pan head screws
through mounting holes on the mounting bracket.
5 Fasten the M4x8 pan head screws with the Phillips
screwdriver.
3
2mm
4
7 4 m m
4 5