(2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Intellijel Designs, Inc. could void the user’s authority to operate the equipment. Any digital equipment has been tested and found to comply with the limits for a ...
Installation Intellijel Eurorack modules are designed to be used with a Eurorack-compatible case and power supply. We recommend you use Intellijel cases and power supplies. Before installing a new module in your case, you must ensure your power supply has a free ...
Page 5
Eurorack case. Ensure the red stripe on the cable lines up with the -12V pins on the bus board. On Intellijel power supplies the pins are labelled with “-12V” and a thick white stripe. ...
Overview Triplatt is a three-channel active/buffered attenuverter and summing mixer. Each channel has a knob, which can function as a unipolar attenuator or a bipolar attenuverter, depending on the setting of its corresponding two-position polarity switch. Each input is normalled to a built-in +5V DC voltage source. With nothing plugged into the jacks, ...
For example: leave the input of Channel A unconnected; set the channel’s polarity switch to -/+ , turn the channel attenuator fully clockwise; and set the Ax2 switch to the down (off) position. Triplatt will send 5V to Channel A’s input . Flip the Ax2 switch to the up ...
Page 8
(on) position, and Triplatt sends 10V (5V x 2) to Channel A’s input. Rotate the knob fully counterclockwise, and Triplatt sends -10V (-5V x 2) to Channel A’s input. The Ax2 switch is a convenient way to double the input voltage, or to set a full +10V or ...
(up). With no cable plugged in, Triplatt sends a 5V DC voltage into Channel A, which you can double to 10V (5V x 2) with the Ax2 switch on. This input input voltage can then be inverted with the polarity switch and scaled with Channel A’s attenuator knob. ...
10 octave range of notes to just one or two octaves in the bass range. One way to do this is to use two channels of a Triplatt. Plug your S&H output into Triplatt’s IN B ; connect OUT B to your oscillator’s pitch input; ...
Page 11
Triplatt to mix multiple channels of audio together as well?” Yes, you can! Set all of Triplatt’s polarity switches to UNI and turn all its knobs fully counterclockwise . Plug the output of one oscillator into IN A , another into IN B , and a third into IN C . ...
Triplatt Manual Block Diagram Below is a block diagram of the signal flow through Triplatt: Technical Specifications Width 6 hp Maximum Depth 21 mm Current Draw 49 mA @ +12V 25 mA @ -12V ...