H3C S9500 Series Operation Manual page 26

Operation Manual – MLD Snooping
H3C S9500 Series Routing Switches
Note:
The above configuration on Router A is for reference only. Refer to the specific situation
of your device when performing the configuration.
3) Configure Switch A
# Create VLAN 100.
<SwitchA> system-view
[SwitchA] vlan 100
# Add ports Ethernet 1/1/1 through Ethernet 1/1/4 to VLAN 100.
[SwitchA-vlan100] port ethernet 1/1/1 to ethernet 1/1/4
[SwitchA-vlan100] quit
# Enable MLD Snooping.
[SwitchA] mld-snooping
[SwitchA-mld-snooping] quit
[SwitchA] vlan 100
[SwitchA-vlan100] mld-snooping enable
[SwitchA-vlan100] quit
# Configure ports Ethernet 1/1/2 and Ethernet 1/1/3 as simulated hosts for IPv6
multicast group FF1E::101:101.
[SwitchA] interface ethernet 1/1/2
[SwitchA-Ethernet1/1/2] mld-snooping host-join ff1e::101:101 vlan 100
[SwitchA-Ethernet1/1/2] quit
[SwitchA] interface ethernet 1/1/3
[SwitchA-Ethernet1/1/3] mld-snooping host-join ff1e::101:101 vlan 100
[SwitchA-Ethernet1/1/3] quit
4) Verify the configuration
# View the detailed information of the MLD Snooping multicast group in VLAN 100.
[SwitchA] display mld-snooping group vlan 100 verbose
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, A-Aggregation port, C-Copy port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):100.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Chapter 1 MLD Snooping Configuration
1-24