Operation Manual – MLD Snooping
H3C S9500 Series Routing Switches
II. Network diagram
Figure 1-3 Network diagram for simulated joining configuration
III. Configuration procedure
1)
Enable IPv6 forwarding and configure IPv6 addresses
Enable IPv6 forwarding on each device and configure an IPv6 address and address
prefix for each interface. The detailed configuration steps are omitted.
2)
Configure Router A
# Enable IPv6 multicast routing, enable IPv6 PIM-SM on each interface, and enable
MLDv1 on Ethernet 1/1/1. The Ethernet 1/1/2 serves as C-BSR and C-RP.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface ethernet 1/1/1
[RouterA-Ethernet1/1/1] mld enable
[RouterA-Ethernet1/1/1] mld version 1
[RouterA-Ethernet1/1/1] pim ipv6 sm
[RouterA-Ethernet1/1/1] quit
[RouterA] interface ethernet 1/1/2
[RouterA-Ethernet1/1/2] pim ipv6 sm
[RouterA-Ethernet1/1/2] quit
[RouterA] pim ipv6
[RouterA-pim6] c-bsr 1::2
[RouterA-pim6] c-rp 1::2
[RouterA-pim6] quit
Chapter 1 MLD Snooping Configuration
1-23