Connection Overview; Step 1: Inserting The Batteries - Sony SAT-A55 Operating Instructions (primary manual) Operating Instructions Manual

Connection
Overview
Follow the procedures or make the connections in
each of the steps to connect your Digital Satellite
Receiver.

Step 1: Inserting the Batteries

v
Step 2: Connecting the Satellite Step 2: Connecting the Satellite
Dish Antenna and Dish Antenna and
Telephone Line Telephone Line
v
Step 3: Connecting Your TV
v
Step 4: Adding a VCR and
Audio System
(advanced connection)
v
Step 5: Connecting the VCR
Controller
(advanced connection)
v
Step 6: Connecting the RF
Antenna (SAT-A55 only)
(advanced connection)
v
Step 7: Connecting the AC
Power Cord
v
Step 8: Inserting the Access
Card
Step 1: Inserting the
Batteries
Before you can use the remote control, you must
insert the supplied batteries. If you want to use this
remote control to operate other audio/video
equipment, such as a TV or VCR, you must set up the
remote control (see page 65).
Page 7
1
Push and slide open the battery
compartment.
Page 8 Page 8
2
Insert two size AA batteries
(supplied).
Be sure to match the + and – marks on the
Page 9
batteries with the + and – marks inside the battery
compartment.
Page 10
Notes
• When the batteries become weak, the Function button
indicators flash. If the remote control does not work
properly, the batteries may be weak.
Page 11
• When replacing batteries, replace both batteries with new
ones. Do not mix different types of batteries together.
• When you remove the batteries, any manufacturer codes
you've set up may be erased. To set up the remote control
again, see "Setting Up the Remote Control" on page 65.
Page 12
Page 13
Page 13
7