Cutting Blades - USCutter Laserpoint II User Manual & Assembly Instructions

Maintenance For Your Cutter
Cutting Strips
for your vinyl cutter will need
to be replaced periodically - we recommend it
be done every six months if you use your vinyl
cutter continuously.
You might need to change out your Cutting
Strips sooner if you start experiencing an uneven
depth of cut, or your material is peeling up even
on slow speeds.
To replace your Cutting Strip:
• USCutter stocks replacement
cutting strips. Go to
USCUTTER.com and search using
the keyword: Cutting Strip.
• Use a weeding tool or other pointed
tool to pry up the existing strip.
(For best results, start at either end
of the strip.)
• Lay replacement into the channel
and use a heat gun or hair dryer to
heat the strip up as you squeeegee it
into place.
• Use a knife to trim the ends of the
strip so that it fits in the channel.
22 24
425.481.3555

Cutting Blades

wear out with use and the
tips of the blades can snap just like the point of
a sharp pencil. (This is particularly true of the
60 degree blade.) You should also periodically
visibly inspect your blades and if you see visible
chips in the edge it's best to replace the blade
with a new one. (This is also a good time to wipe
away any vinyl debris that has built up inside the
blade holder.)
You might also consider the replacement of your
blade if you develop problems weeding or other-
wise experience problems with cut quality.
Refer to the manual section on Blade
Set-up
for instructions on how to install re-
placement blades and remember to dispose of
your old blade safely by putting it in an alumi-
num can or other closed hard container.
www.uscutter.com