Step 3: Connecting Your Tv Set; Step 3: Connecting Your Tv - Sony DIRECTV RECEIVER SAT-W60 Installation Manual

Step 3: Connecting Your TV Set

Satellite Receiver
1c
1b
If your TV has A/V input jacks
1a
Connect the VIDEO OUT jacks on your Satellite Receiver to the
A/V input jacks on your TV using the supplied A/V cable. (Be sure to match the
colors on the jacks with the colored plugs on the A/V cable.) If your TV has only
one audio input, connect it to the L(MONO) jack on the Satellite Receiver.
If your TV has an S-Video input
1b
Use an S-Video cable instead of the yellow video connection. S-Video cable is
supplied.
If your TV does not have A/V jacks
1c
Connect the VHF/UHF OUT jack to the VHF/UHF input jack on your TV using
coaxial cable. Set the CH3/CH4 switch to the channel that does not carry off-air
broadcasts in your area.
Note
With this connection, your input source
is channel 3 or channel 4 depending on
how you set the CH3/CH4 switch on the
Satellite Receiver.
Connecting Your Satellite Receiver
1a
TV
VHF / UHF
IN
VIDEO 1 VIDEO 2
S VIDEO
VIDEO
L
( MONO )
AUDIO
R
11