The EMP-1000HS is capable of running at input voltages of 120 to 240VAC at either 50 or 60Hz. There are no required changes (no fuses to change or buttons to select) to switch from one voltage to the other.
Model EMP-1000HS Installing the Unit: The SEM EMP-1000HS Pulse Degausser was designed to be a very compact unit and to have a small footprint, so that it can fit onto a countertop or into an area where space is limited. See dimensioned diagram below for space requirements.
The Touch Screen Display should illuminate and the product splash screen should appear with the SEM EMP-1000HS product name on a white background. This screen will be displayed for several seconds. For NATIONWIDE SERVICE 800-225-9293 | www.semshred.com...
Page 6
PRODUCT OPERATION & MAINTEANCE PROCEDURE Model EMP-1000HS The Display will now be in the Standby Screen. • The Standby Screen is displayed when the unit is first turned on or when any error or failure is encountered • When in this mode, there is no charging of the unit’s capacitors and the Continue button is always displayed.
Page 7
PRODUCT OPERATION & MAINTEANCE PROCEDURE Model EMP-1000HS The Display will now show the User Screen. • The Charge Indicator (triangle) border turns red indicating that the unit is charging. Black bars inside the triangle appear as the level of charge increases. A blinking icon of a man with a shovel is displayed as the unit charges.
Page 8
PRODUCT OPERATION & MAINTEANCE PROCEDURE Model EMP-1000HS Press "Open Door" to release the media tray. The media tray is now accessible and the media needing to be erased can now be installed. The Start button is disallowed when the door is open.
Page 9
PRODUCT OPERATION & MAINTEANCE PROCEDURE Model EMP-1000HS Install a disk drive into the media tray, as shown. If installing a tape, place the tape onto the center portion of the media tray, as there is more clearance area here to accommodate tapes.
Page 10
PRODUCT OPERATION & MAINTEANCE PROCEDURE Model EMP-1000HS Close the door manually by pushing in the direction shown until it locks in place. PRESS the Start button to begin the degauss cycle AFTER the door has been closed. It will be disallowed if the door is not closed.
Page 11
If FAIL is indicated then the current media should be run again. If FAIL is encountered too many times or if an error is present, please contact the SEM Service Dept. For NATIONWIDE SERVICE 800-225-9293 | www.semshred.com...
The unit is thermally designed to operate "cool". In any degausser, the maximum demagnetizing field produced will drop as temperature rises. The EMP-1000HS is designed with internal heat sinks, optimized routing of air flow, and cooling fans. Under normal operation, the fans are not required and will not run.
PRODUCT OPERATION & MAINTEANCE PROCEDURE Model EMP-1000HS Operating Safety: WARNING!!! HIGH RISK OF SHOCK COULD CAUSE SERIOUS INJURY OR DEATH IF DISASSEMBLED!!! Never attempt to remove the cover, rear panel or disassemble the unit in any way as you could be exposed to a high level shock.
Security Engineered Machinery Co., Inc. 5 Walkup Drive Westborough, MA 01581 Tel: 800-225-9293 Fax: 508-366-6814 Website: www.semshred.com E-mail: service@semshred.com Order Online: www.semshred.com Important Only authorized SEM service personnel should be allowed to service this unit. For NATIONWIDE SERVICE 800-225-9293 | www.semshred.com...