Sony VPL-EX4 Operating Instructions Manual page 36

5
Insert the new lamp all the way in until
it is securely in place (a). Tighten the
two screws (b). Fold down the
handle to replace it (c).
Notes
• Be careful not to touch the glass surface
of the lamp.
• The power will not turn on if the lamp is
not secured properly.
6
Close the lamp cover and tighten the
screw.
Note
Be sure to attach the lamp cover securely
as it was. If not, the projector cannot be
turned on.
7
Turn the projector back over.
8
Connect the power cord.
The ON/STANDBY indicator around
the ?/1 key lights in red.
9
Press the following keys on the
Remote Commander in the following
order for less than five seconds each:
RESET, b, B, ENTER.
To assure reception of signals from the
Remote Commander, press each key at
intervals of 1 to 5 seconds. If the interval
is less than 1 second, the projector may
not receive the signal from the Remote
Commander.
When resetting of the lamp timer has
been done correctly, the red ON/
36
Replacing the Lamp
STANDBY indicator around the ?/1
key turns off for a moment.
Caution
Do not put your hands into the lamp
replacement slot, and do not allow any liquid or
other objects into the slot to avoid electrical
shock or fire.
Disposal of the used lamp
For the customers in the USA
Lamp in this product contains mercury.
Disposal of these materials may be regulated
due to environmental considerations. For
disposal or recycling information, please
contact your local authorities or the
Electronic Industries Alliance
(www.eiae.org).
Lamp contains mercury. Dispose
according to local, state and federal laws.