Projecting - Sony VPL-CX21 Operating Instructions Manual

To connect to a video GBR/
Component output connector
Left side
White Red
to to
audio audio
output output
(L) (R)
A SMF-402 Signal Cable (not supplied)
HD D-sub 15-pin (male) ↔ 3 × phono jack
B A/V connecting adaptor (supplied)
C Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
Note
Set the aspect ratio using "Wide Mode" on the
Signal menu according to the input signal.
to video
GBR/
component
output
VCR

Projecting

ON/STANDBY indicator
Rear remote control
detector
APA INPUT
KEY
STONE /TILT
LENS
ENTER
AUTO
RESET MENU
FOCUS
FREEZE
D ZOOM VOLUME
PIC AUDIO
MUTING MUTING
1
Plug the AC power cord into a wall
outlet, then connect all equipment.
The ON/STANDBY indicator lights in
red and the projector goes into standby
mode.
2
Press the ?/1 key.
The ON/STANDBY indicator flashes in
green and the Advanced Intelligent
Auto-setup starts. The powered tilt
adjuster rises and stops at the previously
adjusted position and adjusts the focus.
Note
The projection size that can be adjusted
with the automatic focus adjustment is
from 40-inch up to 150-inch. However, it
11
Projecting