Sony VPL-CX100 Operating Instructions Manual page 42

Setting items
ID Mode
(VPL-CX125/
CX155/CW125
only)
Direct Power On Set to "On" if you are using a circuit breaker to turn the
High Altitude
Mode
Notes
• The auto V Keystone adjustment may not correct the trapezoidal distortion perfectly, depending
on the room temperature or the screen angle.
• If you need fine adjustment when V Keystone is set to "Auto", press the KEYSTONE key on the
control panel or the remote commander, and change the value. The setting mode will be
temporarily changed to "Manual" from "Auto".
• If you want restore the "Auto" setting, first switch the V Keystone setting to "Manual", then return
it to "Auto".
• When you want to apply the fine adjustment value the next time, change the V Keystone setting to
"Manual" from "Auto".
• If High Altitude Mode is set to "On" at an altitude under 1,500 m, the reliability of the lamp may
be diminished.
42
The Installation Menu
Functions
Assigns an ID number (1 to 3) to the projector when you
want control two or more projectors individually with the
supplied Remote Commander. When this item is set to "1,"
you can control the projector with the Remote Commander
with the ID MODE key set to "1." When it is set to "All,"
you can control all the projectors with the Remote
Commander independently of the ID MODE keys of the
Remote Commander.
power on/off the entire system.
You can turn the power on/off without pressing the power
key on the projector.
Set to "On" when the projector is used at an altitude of
1,500 m or higher.
Initial setting
All
Off
Off