Sony VPL-CX100 Operating Instructions Manual page 27

To operate with the Control Panel
or the Remote Commander of
VPL-CX100/CX120/CX150
Each time you press the INPUT key, the
input signal switches as follows:
* VPL-CX125/CX155/CW125 only
To input from
Computer, Component,
Video GBR etc.
connected to the
INPUT A connector
Computer, etc.
connected to the
INPUT B connector
Computer connected to
LAN to use the network
presentation function
Video equipment
connected to the VIDEO
input connector
Video equipment
connected to the
S VIDEO input
connector
Notes
• If "Auto Input Search" is set to "On," the
projector searches for the signals from
the connected equipment and displays
the input channel where the input signals
are found.
• When the no signal is input to the VPL-
CX125/CX155/CW125, "Input-C" is
selected.
For details, see "Auto Input Search" in
the Function Menu on page 39.
5
Switch the equipment connected to
output to the projector.
Depending on the type of your
computer, for example a notebook, or an
Press INPUT
to display
Input-A
Input-B
6
Input-C
(VPL-
CX125/
CX155/
CW125 only)
Video
S-Video
all-in-one LCD type, you may have to
switch the computer to output to the
projector by pressing certain keys (e.g.,
, etc.), or by
changing your computer's settings.
or
and
Note
The key used for switching the computer to
output to the projector varies depending on
the type of computer.
Adjust the upper or lower position of
the picture.
Use the adjuster to adjust the picture
position.
Using the adjuster
1 Lift the projector while pressing the
Adjuster adjustment button.
2 Adjust the tilt of the projector.
3 Release the Adjuster adjustment
button.
4 When fine-tuning is necessary, turn
the Adjuster right and left.
2
13
4
Notes
• When you adjust the tilt of the projector
with the adjuster, the V keystone
27
Projecting