Step 3: Adjusting The Picture Position - Sony VPL-BW5 Operating Instructions (VPL-BW5) Operating Instructions Manual

Step 3: Adjusting the Picture Position

Project an image on the screen and adjust the picture position.
8 7
1
After connecting the AC cord to
the projector, plug the AC cord
into a wall outlet, connect all
equipment, and remove the lens
cover.
The ?/1 (On/standby) switch lights in
red and the projector goes into standby
mode.
2
Press the / (On/standby)
? 1
switch to turn on the projector.
The ?/1 (On/standby) switch flashes in
green, then lights in green.
22
1,2 4
Rear remote
control detector
1 5
4
3
4
6
Turn on the equipment
connected to the projector.
Refer to the operating instructions of the
connected equipment.
Press INPUT to project the
picture on the screen.
Each time you press the button, the input
indication and equipment to be projected
change. (1 page 27)
2
6