Snmp - Sony SRX-T420 Installation Manual

2-2-6. SNMP

SNMP (Simple Network Management Protocol) is set.
Fig. 2-2-6
SNMP
sysName:
Contact:
Location:
Send authentication trap: Place a check mark when accepting the sending of authentication trap.
Accept SNMP packets from any host:
Accept SNMP packets from these hosts: Select this when accepting the access only from the specifi ed
(Address):
[>>] button:
[<<] button:
(Registration list):
Community:
. [Add] button:
. [Edit] button:
. [Remove] button:
Community name:
Rights:
[Set|to|List] button:
[Cancel] button:
Trap Destinations:
[>>] button:
[<<] button:
(Registration list):
2-10
Type the character string of standard MIB sysName.
Type the character string of standard MIB sysContact.
Type the character string of standard MIB sysDescr.
Select this when accepting the access from any host.
host.
Type the IP address of the host that you accept the access.
Add the typed IP address of the host to the list.
Delete the typed IP address of the host from the list.
Registration list of the IP address of the host that you accept the access.
Edit and select the community name.
Add the community name.
Allow the selected community to enter the attribute edit mode.
Delete the selected community.
When the [Edit] button is clicked, the community whose attribute is changed
appears and the following items are enabled.
Select the access authority.
Attribute change is applied.
Attribute change is cancelled.
Type the IP address of the host of the trap destination.
Add the typed IP address of the host to the list.
Delete the typed IP address of the host from the list.
Registration list of the IP address of the host of the trap destination.
SRX-T420