Table of Contents
Advertisement
AV2 OUTPUT
This option allows you to select the source to be output from the Scart connector
record from this Scart any signal coming from the projection TV or from an external equipment connected
to the Scart connector
To do this:
Once you have entered into the "Features" menu as it is explained in the previous page and after selecting
the option, press
• TV to output the aerial source.
• AV1 to output sources connected to
• AV3 to output sources connected to
• YC3 to output sources connected to
• AUTO to output the signal that is being viewed on the TV.
PIP INPUT
This option allows you to select the source you want to watch in the "PIP" screen.
To do this:
Once you have entered into the "Features" menu as it is explained in the previous page and after selecting
the option, press
press OK to store.
PIP POSITION
This option allows you to change the position of the "PIP" screen within the main screen.
To do this:
Once you have entered into the "Features" menu as it is explained in the previous page and after selecting
the option, press
18
The General TV Menus
1/
If your VCR supports SmartLink, this procedure is not necessary.
b
v
. Then press
• If you select "AUTO", the output signal will always be the same one that is displayed on the screen.
• If you have connected a decoder to the Scart
remember to change back the "AV2 Output" to "AUTO" or "TV" for correct unscrambling.
b
v
. Then press
B
B
B
v
V
B
b
/
/
or
1 or side connectors
3 or
S
V
to select the desired output signal:
or
1/
1.
3 and
3.
3 and
3.
S
2/
V
or
repeatedly to select the desired source AV1, AV2, AV3 or TV. Finally
To watch the "PIP" screen with the selected source, press
the
/
You can swap the screens by pressing the
the remote control.
to select the desired position. Finally press OK to store.
2/
3 and
3.
2 or to a VCR connected to this Scart, please
S
button on the remote control.
2 so that you can
S
/
button on
Advertisement
Table of Contents
