Receiver (Sat); Setting The Manufacturer's Code - Sony KP 48S70 Operating Instructions Manual

Operating a Cable Box or Satellite Receiver (SAT)
Setting the Manufacturer's
Code
You can program the supplied remote control
to operate a cable box or satellite receiver.
Press CODE SET, SAT/CABLE
(FUNCTION), and the 0-9 buttons to enter
the manufacturer's code number (see the
following chart), then press ENTER.
For example, to operate a Sony satellite receiver:
FUNCTION
CODE SET
SAT/CABLE
8 0
Manufacturer code numbers
(cable box)
Manufacturer
Hamlin/Regal 222, 223, 224, 225, 226
201, 202, 203, 204, 205,
Jerrold/G.I
222, 206, 207, 208, 218
Oak
Panasonic
Pioneer
Scientific Atlanta
Tocom
Zenith
Manufacturer code numbers
(satellite receiver)
Manufacturer
Sony
General Electric
Hitachi
Hughes
Panasonic
RCA/PROSCAN
Toshiba
ENTER
1
To operate the cable box or
satellite receiver (SAT)
1
Press SAT/CABLE (POWER) [Green
Button] to turn on/off the cable box or
satellite receiver.
Code
2
Press SAT/CABLE (FUNCTION).
3
For other operations, refer to the
operating instructions that come with the
227, 228, 229
equipment.
219, 220, 221
The GUIDE and INDEX (blue-labeled)
214, 215
buttons can be used only with a satellite
209, 210, 211
receiver.
216, 217
212, 213
If the remote control doesn't work
• Try repeating the set up procedures using
the other codes listed for your equipment.
To operate the projection TV
Press TV (FUNCTION). Then use the
projection TV control buttons to control the
Code number
projection TV.
801 (preset code for
remote control)
802, 808
Tips z
805
• If more than one code number is listed, try entering
804
them one by one until you come to the correct code
803
for your equipment.
802
• If you enter a new code number, the code number
806, 807
you previously entered at that setting is erased.
• In some rare cases, you may not be able to operate
your equipment with the supplied remote control. In
this case, use the equipment's own remote control
unit.
• Whenever you remove the batteries — to replace
them, for example — if too much time is taken, the
code numbers may revert to the factory setting and
must be reset.
45