Readytools Dial; The Flow Indicator - Bissell 7901 SERIES User Manual

When It's Time to Empty Tank-in-Tank Continued
Remove Tank Lid by rotating handle forward to unlatch
3.
lid and lifting lid off tank.
Pour out dirty water.
4.
After each use, remove and rinse the lint screen located
5.
on the tank lid.
A. Remove tank assembly from unit.
B. Remove tank lid.
C. Remove any debris caught in lint screen.
D. Reinsert lint screen on tank lid. The screen will
click into place
E. Replace tank lid.
F. Reinsert tank assembly into unit.
Refill with clean tap water as above, steps 5 through 9
6.
on page 8, and refill the SmartMix bottle with BISSELL
Fiber Cleansing Formula as necessary.
When the cleaning job is complete, rinse out the
7.
Tank-in-Tank by rinsing clean water between the bladder
and tank.
Return Tank-in-Tank to the machine, following steps 6
8.
through 9 on page 8.
Refer to the Maintenance section, pg. 17 for the
9.
final cleanup.

The Flow Indicator

The Flow Indicator is located on the machine base. It spins when
the trigger is pressed to indicate that the machine is applying
cleaning solution to the floor. It will stop spinning to indicate that the
SmartMix bottle or bladder needs to be refilled, or when the trigger
is released. Flow Indicator does not spin when set to Tool setting.

ReadyTools Dial

This provides above floor cleaning with the flip of a switch.
Just choose the cleaning tool or protector applicator, attach
to the flex hose and ProHeat is ready to clean
upholstery, stairs or apply extra protection against dirt and
tough stains when using the Scotchgard protector applicator.*
*Set the dial to Floor Cleaning when cleaning
carpets or bare floors or set it to Tools/PreTreat
when using the flex hose attachments or for
pre-treating floors, or when applying the
Scotchgard protector applicator.
*SmartTemp heats the cleaning solution for carpet
and bare floor application only. It does not heat
solution sprayed through the accessory tools.
Pour out
3
Rotate Handle to 4
dirty water
Unlatch
5D
5C Lint Screen
3
Fill bladder
8
only with clean
6
hot tap water
Tip:
A special red
float device
in the tank will
cause the cl e aner
to stop removing
Tip:
solution from the
carpet and the
Thorough
motor sound will
vacuuming
rise in pitch to let
before deep
you know the
cleaning will
dirty water tank is
prevent early
full.
clogging of
lint trap.
Flow Indicator
ReadyTools Dial
Latched
9