Bare Floor Cleaning Technique; Routine Maintenance - Bissell 7901 SERIES User Manual

Bare Floor Cleaning Technique

Slowly move the machine nozzle with Bare Floor Tool
1.
forward and back over soiled surface one time while
pressing the trigger. Caution: Do not over wet.
Repeat the motion without pressing the trigger using the Bare
2.
Floor Tool to squeegee and suction up the dirty water.
Repeat steps 1 and 2 backing along the exit path.
3.
Allow about 30 minutes for the floor to dry completely.
4.
When the cleaning job is complete refer to the
5.
Maintenance/Storage section on page 17-20.
To remove Bare Floor Tool gently bend long tab (right side)
6.
outward and pull tool down away from nozzle. Rinse
thoroughly, dry and store

Routine Maintenance

Turn Power and SmartTemp switches OFF.
1.
Unplug power cord from the outlet and coil around Power Cord
2.
Quick Release.
Remove and rinse tools in clean, running water, dry and
3.
replace tool caddy.
Coil flex hose around storage brackets on tool caddy.
4.
Remove Tank-In-Tank, dispose of dirty water. See Features
5.
section, Page 7-9.
Rinse out Tank-In-Tank and replace on the machine; Clean out
6.
lint trap.
Clean out the Flow Indicator Filter each time it is used to ensure
7.
best cleaning performance. Unscrew the Flow Indicator Cap, lift
out the red rotor and white filter. Rinse all three parts in tap water.
Replace the filter and rotor. Replace the Flow Indicator Cap; turn
until snug, do not over-tighten.
Wipe all exterior surface with a soft cloth.
8.
Store cleaner upright in a protected, dry area.
9.
Note: ProHeat uses water and must not be stored
where there is a danger of freezing. Freezing will dam-
age internal components and void the warranty.
When carpet is dry, vacuum again to remove hair and fuzz
10.
that the ProHeat may have loosened.
WARNING:
To reduce the risk of fire,
electric shock or injury
unplug from outlet
before servicing.
Tip:
SmartMix Bottle
may be stored
with concentrate
ready for your
next cleaning job.
Make sure dial is
turned to the
Water Rinse/
Carpet Protector
Setting when
storing.
Cap
Rotor
Filter
17