Table of Contents
Advertisement
2.4 Installation - Checking Parts
No.
Name
1
2
3
Connection pipe
Condensate pipe
4
5
frame
Connecting
6
cable(power cord)
7
Wall pipe
Note:
2.5 Selection of Installation Location
1. Basic Requirement:
Areas
Areas
Areas with salty vapor in the air
Areas
Areas
sulfuric
areas
2. Indoor Unit:
a
appliance.
should
3. Outdoor Unit:
have minimal effect on surrounding
neighbors
wind.
requirements outlines in the installation dimension diagram.
ing
s
4
No.
Name
Sealant
8
9
Wrapping tape
10
11
12
13
remote controller
s
source
an
a
area
complies with the
2.6 Electric Connection Requirement
1. Safety Precautions
(1) All electric safety regulations must be followed when
installing the unit.
(2) Use proper power supply circuit and air switch in
accordance with local safety regulations.
(3) The power supply must be sized to meet the requirements
of air conditioning unit. Incorrect sizing/wiring may result in
electric shock, fire hazard or malfunction.
Air-conditioner
09K
12K
18K
(4) Properly connect the live wire, neutral wire and grounding
wire of power socket.
(5) Be sure to cut off the main power supply before performing
any electrical work.
(6) Do not turn power back on until installation is complete.
(7) For appliances with type Y attachment,the instructions shall
contain the substance of thefollowing. If the supply cord is
damaged, it must be replaced by the manufacturer, its service
agent or a qualified technician to avoid any shock hazards.
(8) The temperature of refrigerant circuit will be high, please
keep the interconnection cable away from the copper tube.
2. Grounding Requirements:
The air conditioning unit
unit
wiring.
e
to
2.7 Installation of Indoor Unit
1. Choosing Installation Iocation
conditions; then proceed after client approval.
2. Install Wall-mounting Frame
securing
.
15A
20A
30A
ed
certified technician.
accessible.
. P
with
. I
P
only
based on field
Installation and Maintenance
a
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Z Series and is the answer not in the manual?