Advertisement
POWER SUPPLY 1:
a. Remove the five screws from the top of the power supply (see Figure 11).
b. Remove one screw from the side of the power supply (see Figure 11).
c. Remove one screw from the back of the power supply (see Figure 12).
d. Cut the two plastic ties that secure the wires to the power supply cover (see Figure 12).
e. Remove the cover by moving the wires aside so they do not block cover removal, then rotating the cover outward,
and then sliding the cover toward the front of the power supply so the two tabs slide out of the chassis. Lift the cover
off the power supply.
f. Cut the wires from the PCA.
g. Remove the three screws that secure the power supply PCA to the power supply (see Figure 13).
h. Remove the power supply PCA from the power supply.
i. Remove one capacitor as shown in Figure 13.
POWER SUPPLY 2:
a. Remove the three screws from the top of the power supply (see Figure 14).
b. Remove one screw from the front of the power supply (see Figure 15)
c. Cut the two plastic ties that secure the wires to the power supply cover (see Figure 15).
d. Remove the cover by prying/lifting the lift side of the cover (over the fan), moving the wires so they do not block
cover removal, and then rotating and lifting the cover from the power supply.
e. Cut the wires from the PCA.
f. Remove the three screws that secure the large power supply PCA to the power supply (see Figure 16).
g. Remove the large power supply PCA.
h. Cut one capacitor from the PCA as shown in Figure 17.
i. Cut the small PCA from the large power supply PCA, as shown in Figure 17.
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
EL-MF877-00
Template Revision A
Page 3
Advertisement
