H3C S9500E Series Command Reference Manual page 137

Field
Control VLAN
Protected VLAN
Hello Timer
Fail Timer
Fast Detection Status
Fast Hello Timer
Fast Fail Timer
Ring ID
Ring Level
Node Mode
Ring State
Enable Status
Active Status
Primary Port
Description
Control VLANs of the RRPP domain:
•
Major—Primary control VLAN.
•
Sub—Secondary control VLAN.
List of VLANs protected by the RRPP domain. MSTIs are displayed here. To
get the VLANs corresponding to these MSTIs, use the display stp
region-configuration command.
Hello Timer value in seconds.
Fail Timer value in seconds.
Fast detection mechanism status:
•
Enable for enabled.
•
Disable for disabled.
The interval specified in milliseconds at which the master node sends
Fast-Hello packets out of the primary port.
The maximum delay specified in milliseconds between the master node
sending Fast-Hello packets out of the primary port and the secondary port
receiving the Fast-Hello packets from the primary port.
RRPP ring ID.
RRPP ring level:
•
0—Primary ring.
•
1—Subring.
Node mode:
•
Master node.
•
Transit node.
•
Edge node.
•
Assistant edge node.
RRPP ring state:
•
Complete—The ring is healthy.
•
Failed—The ring is not closed.
If the ring is not enabled on the device working as the master node or the
device is not the master node of the ring, a hyphen (-) is displayed.
RRPP ring enable status:
•
Yes for enabled.
•
No for disabled.
RRPP ring activation status. An RRPP ring can be active only when the RRPP
protocol and the RRPP ring are both enabled. You can also use this field to
identify whether the RRPP protocol are enabled. Two statuses are available:
•
Yes for active.
•
No for inactive.
The primary port field means the node mode is master node or transit node.
A hyphen (-) appears when the port is not configured on the ring or the
board to which the port belongs does not start.
127