Related Manuals for Lakes Bathrooms Coastline Series
Summary of Contents for Lakes Bathrooms Coastline Series
- Page 1 COASTLINE Walk In Range Installation / Maintenance Instructions Rev 10.12 Lakes Bathrooms Typical variants shown, actual unit may differ in appearance.
-
Page 2: Important Notes
However should maintenance be required it should be carried out by a competent person with reference to these instructions. Before any work is carried out the root cause of the problem must be identified. Lakes Bathrooms service engineers are available if necessary to consult / carry out remedial work. Call Lakes Bathrooms HELPLINE. - Page 3 MODELS Cannes Riviera Nice (or Side Panel) (Riviera *) Palma Andora Rhodes Unit Comprises Cartons Cannes LK810 Riviera LK811 Riviera * LK819 Nice LK812 Palma LK812 + LK810 Andora LK814 + LK818 Rhodes LK814 + LK818 + LK810 Marseilles LK815 + LK818 Marseilles...
- Page 4 Supplied Parts : LK810 LK811 LK812 LK814 LK815 LK818 LK819 Panel Sub Assy Type A Panel Sub Assy Type B Panel Sub Assy Type C Panel Sub Assy Type D Panel Sub Assy Type E Glass (only) Bracing Arm Main Type (M) Bracing Arm Screen...
- Page 5 Tools Required 2,5mm Hexagon Spirit Level (with vertical ―bubble‖) Pozidriv Screwdriver (Allen) Key Tape Measure Pencil Power drill & 8mm masonry bit Hacksaw 3mm HSS Good quality silicone drill bit sealant & applicator Lakes Coastline Walk In enclosures are fully reversible. Versatile construction permits their use onto a wide range of base footprints, tray or wetroom installations.
- Page 6 Select Hand ~ Fit bottom trims Select ―hand‖ for unit build. Trims are fitted at base only. Carefully push trims fully onto bottom edges of glass panels. Butt trims upto vertical profiles (centre on 819). Do not bend or strike with hard objects, a soft mallet or hammer & wooden block should be used.
- Page 7 Foot Kit : (Models 812 & 814 Bypass Panel ~ Over Tray Recess Mounted). 3. Refit spacer into foot, apply ―blob‖ 1. With unit supported in 2. Using scale, cut spacer of silicone sealant to base of foot assy. position & plumb, measure to measured size.
- Page 8 Bracing (continued.) Assemble bracing bar(s) onto enclosure ; do not tighten clamps at this time. Lightly mark bracket positions on panels. Align / plumb & mark wall bracket hole positions, drill, plug & mount wall bracket. Refit glass bracket(s) & tighten all glass clamp screws (1) Assemble bars(s) &...
- Page 9 SEALING : Use of good quality silicone sealant & cleaning / degreasing of all joint areas is recommended. Apply continuous silicone sealant bead EXTERNALLY ONLY to all panels in contact with tray rim / floor & vertically approx 50mm (2”) between wall & wall profile.
-
Page 10: Basic Troubleshooting
& leakage does occur, additional silicone sealant may be applied over full length of wall profile / wall joints. Lakes Bathrooms Service : Northern Ireland Lakes Bathrooms Ltd Ian A Kernohan Alexandra Way Firtrees Ashchurch Green Way Industrial Estate...