Each Setting And Adjustment; Adjustment Required When The Unit Is Repaired Or Replaced - Pioneer VSX-1128-K Service Manual

1

8. EACH SETTING AND ADJUSTMENT

A
• If the adjustment is shifted or if it becomes necessary to readjust because of part replacement, etc., perform the
adjustment as described below.
• Any value changed in Adjustment mode will be stored in memory as soon as it is changed. Before readjustment, take note of
the original values for reference in case you need to restore the original settings.
• Use a stable AC power supply.
B

8.1 ADJUSTMENT REQUIRED WHEN THE UNIT IS REPAIRED OR REPLACED

When any of the following assemblies is replaced
C
AMP7 Assy
D-MAIN Assy
Other assemblies
D
When any of the following parts is replaced
AMP7 Assy
Other assemblies
E
Note 1:
Some parts on D-MAIN and FHDMI Assemblies can not be replaced due to using heat-pad connection between the board.
Please refer to [1.2 NOTES ON REPLACING PARTS], when the parts listed in the table is defective, replace whole Assy.
Note 2:
After replacing D-MAIN Assy, the unit needs to reset factory default settings.
Refer to "Resetting the system" on "6.2 DEFAULT SETTINGS" , reset the unit.
F
44
1
2
"8.4 IDLE CURRENT ADJUSTMENT" (All channel)
"8.2 USB BACKUP"
No adjustment required
"8.4 IDLE CURRENT ADJUSTMENT"
(Only channel of replacement parts)
No adjustment required
VSX-1128-K
2
3
3
4
4