Hooking Up The Sprayer - Hardi ES 30 Operator's Manual

3.0 HOOKING UP THE SPRAYER

TOW VEHICLE REQUIREMENTS:
Lawn & Garden tractor or ATV with a drawbar with sufficient horse-
power and braking ability to safely control the following specifications:
Sprayer Total Loaded Weight (lbs.)
ES 30
ES 50
1. ES 30 and ES 50: Attach sprayer tongue to drawbar with the
correct size drawbar pin and install safety clip.
SM 50: Secure sprayer to bed of truck/utility vehicle. The SM 50
weighs 84 lbs empty (plus weight of spray liquid).
2. The electrical wiring for the 12 Volt pump must be completed
before first time use. If this has already been done, skip to step 3.
If not, locate a place to mount the supplied switch within easy
reach of the operator. Use Fig. 1 as a guide to connect the pump
to the supplied wires, switch, inline fuse and alligator clips. Make
sure that the switch and inline fuse are installed in the white wire
(+) connected to the pump's red wire (+).
3. With the switch in the "off" position, connect the alligator clip on
the white wire (+) to the positive terminal of the 12 Volt battery and
connect the alligator clip on the black wire (-) to the negative
terminal of the battery. For ES 30 and ES 50, ensure that there is
enough slack in the wiring between tow vehicle and sprayer to
prevent damage to wires when turning.
4. Tire pressure should be 10 PSI (ES 30, ES 50 only).
INLINE FUSE
+
®
HARDI
396
598
-
ALLIGATOR
CLIPS
12 VOLT ESTATE SPRAYER OPERATOR'S MANUAL
Tongue Weight (lbs.)
SWITCH
WHITE WIRE
CONNECTORS
BLACK WIRE
Fig. 1
26
68
PUMP
RED WIRE
BLACK WIRE
9