Change Of The Unitcode; Change Of The Battery; Applications - Marmitek X10 SS12E User Manual

CHANGE OF THE UNITCODE

When setting up the UnitCode the left button is set up in
the desired UnitCode. The right button is always
automatically one UnitCode higher.
1. Press the left OFF button and keep it pressed. The red
LED flashes shortly. After 15 seconds the present set
up is shown: 1 flash is UnitCode 1, 2 flashes is
UnitCode 2 etc.
2. Release the OFF button.
3. Now press shortly for the desired UnitCode on the
same OFF button (1x = 1; 2x = 2 etc.) The Led flashes
every time you press the button.
4. At the last time keep the button pressed. After 3
seconds the LED shows the set-up UnitCode. Now
release the button.

CHANGE OF THE BATTERY

Remove the right rocker switch at
the front of the SS12 and replace
the battery.
Use an identical 12V Alkaline
battery (type A23). Mind the
polarity when replacing.

APPLICATIONS

With the Marmitek X10 SS12 wireless switch you can
activate pre-programmed macros in the CM15Pro
computer interface.
You can also use the SS12 as a central operation panel for
your Marmitek installation.
8
© MARMITEK