Connection To The Mains - Sherman Workshop MIG 200M User Manual

Duty cycle
Duty cycle is based on a period of 10 minutes. Duty cycle of 60% means that after 6 minutes of operation of the device is required for 4-minute break.
Duty cycle of 100% means that the machine can operate continuously without interruption.
Attention! Heating test was carried out in the ambient air temperature. Duty cycle at 40 ° C was determined by simulation.
Level of security
IP specifies the extent to which the device is resistant to entering of solid impurities and water. IP21 means that the device is suitable for use in
confined spaces and is not suitable for use in the rain and snow.
5. PREPARING TO WORK EQUIPMENT
5.1 CONNECTION shielding gas
1. Attach the bottle and secure it against tipping.
2. Remove the cylinder valve briefly to remove any impurities.
3. Install the regulator on the cylinder.
4. Connect the hose from the regulator welder.
5. Remove the cylinder valve and regulator.

5.2 CONNECTION TO THE MAINS

5.2 CONNECTION TO THE MAINS
1. A device 200M MIG should only be used in a single-phase, three-wire with grounded neutral.
2. Semi-automatic MIG welding 200M is adapted to cooperate with 230V 50Hz 32A fused time-delayed action.
3. The device is equipped with a power cord and a plug. Before connecting, make sure the power switch located on the rear panel is in the OFF
position (off).
5.3 ESTABLISHMENT reel wire electrode
1. Open the side housing cover.
2. Check that the drive rollers are suitable for the wire size and type.
3. Place the spool of wire electrode on the stem.
4. Secure the spool from falling.
5. Release the pressure feed rollers.
6. blunt end of the electrode wire.
7. Enter the wire by the driving roller tray holder.
5