Table of Contents
Advertisement
Poisoning prevention vapors and gases evolved at the time of welding of coatings for welding electrodes and evaporation of metals:
•
Use ventilation and exhaust installed in limited air exchange.
•
Blow fresh air when working in a confined space (tanks)
•
Use masks and respirators.
Preventing burns:
•
Wear suitable protective clothing and footwear to protect from burns from arc radiation and spatter,
•
Avoid contamination of clothing lubricants and oils that may lead to its inflammation.
Explosion prevention and fire:
•
Do not operate the machine and welding in areas at risk of explosion or fire,
•
Welding station should be equipped with fire-fighting equipment,
•
Welding station should be located a safe distance from flammable materials.
Preventing negative effects of noise:
•
Wear earplugs or other protection against noise,
•
Warn people about the danger nearby.
WARNING!
Do not use the power source for thawing frozen pipes.
Before starting the unit:
•
Check the condition of electrical and mechanical connections. It is forbidden to use handles and load wires with damaged insulation.
Inadequate insulation handles and cables current danger of electric shock,
•
Ensure proper operating conditions, ie. To ensure proper temperature, moisture and ventilation in the workplace. Outdoors closed to protect from
rain,
•
Place the charger in a place that allows its easy handling. Persons operating welder should:
•
have the power to electric welding MMA and MIG / MAG
•
know and comply with applicable health and safety regulations when performing welding work,
•
use proper, specialized protective equipment: gloves, apron, rubber boots, shield or welding helmet with a suitably selected filter
•
know the contents of this manual welder and operated in accordance with its intended purpose. Repair work may only be carried out
after removing the plug from the wall socket.
When the device is connected to the network is not allowed to touch the bare hand or by any wet clothing elements forming the welding current
circuit.
It is forbidden to remove the outer casing when the device is turned on to the network. Any alteration of the rectifier on their own are
prohibited and may constitute a deterioration in security conditions.
All maintenance and repair may only be performed by authorized persons with the conditions applicable to the safety of electrical equipment. Do not
operate the welder in areas at risk of explosion or fire! Welding station should be equipped with fire-fighting equipment. After working the machine power
cord must be disconnected from the network.
The above risks and the general safety rules is not exhaustive safety of the welder, since it does not take into account the specifics of the workplace.
They are an important complement to bench safety instructions and training and briefings given by supervisory staff.
3
Hide quick links:
Advertisement
Table of Contents
