H3C S9500 Series Operation Manual page 29

Operation Manual – IGMP Snooping
H3C S9500 Series Routing Switches
II. Network diagram
Figure 1-5 Network diagram for static router port configuration
III. Configuration procedure
1) Configure IP addresses
Configure an IP address and subnet mask for each interface as per
detailed configuration steps are omitted.
2) Configure Router A
# Enable IP multicast routing, enable PIM-DM on each interface, and enable IGMPv2
on Ethernet 1/1/1.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface ethernet 1/1/1
[RouterA-Ethernet1/1/1] igmp enable
[RouterA-Ethernet1/1/1] igmp version 2
[RouterA-Ethernet1/1/1] pim dm
[RouterA-Ethernet1/1/1] quit
[RouterA] interface ethernet 1/1/2
[RouterA-Ethernet1/1/2] pim dm
[RouterA-Ethernet1/1/2] quit
Note:
The configurations mentioned above are for reference only. Specific configurations are
subject to the implementations of the devices.
Chapter 1 IGMP Snooping Configuration
1-27
Figure 1-5. The