H3C S9500 Series Operation Manual page 27

Operation Manual – IGMP Snooping
H3C S9500 Series Routing Switches
II. Network diagram
Figure 1-4 Network diagram for IGMP Snooping querier configuration
III. Configuration procedure
1) Configure switch A.
# Enable IGMP Snooping globally.
<SwitchA> system-view
[SwitchA] igmp-snooping
[SwitchA-igmp-snooping] quit
# Create VLAN 100 and add Ethernet 1/1/3 and Ethernet 1/1/1 to VLAN 100.
[SwitchA] vlan 100
[SwitchA-vlan100] port ethernet 1/1/1
[SwitchA-vlan100] port ethernet 1/1/3
# Enable IGMP Snooping in VLAN 100 and enable the IGMP-Snooping querier feature.
[SwitchA-vlan100] igmp-snooping enable
[SwitchA-vlan100] igmp-snooping querier
# Set the source IP address of IGMP general queries and group-specific queries to
192.168.1.1.
[SwitchA-vlan100] igmp-snooping general-query source-ip 192.168.1.1
[SwitchA-vlan100] igmp-snooping special-query source-ip 192.168.1.1
2) Configure Switch B.
# Enable IGMP Snooping globally.
<SwitchB> system-view
[SwitchB] igmp-snooping
[SwitchB-igmp-snooping] quit
Chapter 1 IGMP Snooping Configuration
1-25