American Panel Walk-in Monitoring System 100 Owner's Manual page 9

Ex2: If the flashing value is set to 100P (100%), the door frame heater will run continuously.
Ex3: If the flashing value is set to 0P (0%), the door frame heater will not run at all.
Ex4: If the flashing value is set to 50P (50%), the door frame heater will
2 minutes. The cycle will repeat for as long as the controller will be on.
Note : Do not set Door Frame Heater Percent to 0P (0%) unless you want to turn the door frame heater
off.
Press when done.
A larm Settings - High Air Alarm
Press or
goes above this set point, the alarm will go off.
Press when done.
Alarm Settings - Low Air Alarm
Press or
goes below this set point, the alarm will go off. You can set low air alarm anywhere between -30
Press when done.
to change the flashing value representing degrees Fahrenheit. If the air temperature
to change the flashing value representing degrees Fahrenheit. If the air temperature
run for 2 minutes and it will be off for
The display will show:
The display will show:
PROGRAMMING
(Default value for coolers)
(Default value for freezers)
(Default value for coolers)
(Default value for freezers)
0 0
F and 50 F.
7