American Panel Walk-in Monitoring System 100 Owner's Manual page 7

Press .
Real Time Clock Settings
Press or
real time clock is enabled, the time will be displayed during normal operation.
Press when done.
Press or
Press and hold
Press when done.
Door Frame Heater Settings
This function will turn the door frame heater on or off.
By default, the door frame heater is set to on ("1"). If you wish to turn the door frame heater off, change the
flashing value from "1" to "0" (off) by pressing
Press when done.
Note: If you set the flashing value to "0", door frame heater off, the controller will skip to alarm settings. In
case the flashing value is set to "1", door frame heater on, the controller will guide you thru door frame heater
settings
.to set the flashing value to "1" (Enabled) if you wish to enable the real time clock. If
.to change the flashing value to current time in one minute increments.
or to change the current time in thirty minute increments.
The display will show:
The display will show:
The display will show:
The display will show:
or .
PROGRAMMING
5