American Panel Walk-in Monitoring System 100 Owner's Manual page 14

PROGRAMMING
Enter The New Code
Enter any three key combination of the following buttons:
Next, the controller will display for a second the message shown in the figure below and then switch to the three
dashes display.
Re-enter the new code.
After successfully re-entering the new code, the controller will briefly display the message shown in the figure
below.
If you wish to skip parameter programming press
To change the controller parameters, see the "Parameter Programming" section of this manual.
Make a note of the new code.
12
The display will show:
The display will show:
The display will show:
The display will show:
until you get to the OFF message.
.