Table of Contents
Advertisement
3. If you see the screen above, perform the following steps to apply the software. Otherwise
skip to step 4.
a. With [Perform Initial Install or Factory Reset] selected, press Enter.
b. Use the Up and Down arrow keys to select
"CommandPost", and press Enter.
The system displays a screen with the
message "Congratulations, your CentOS
installation is complete."
c. Press Reboot.
4. Use these credentials at the login prompt:
−
user: fidelis
−
default password: fidelispass
5. From the command line, run: sudo /FSS/bin/setup
You will be prompted for the SU (fidelis) password
6. Within Setup, select Network Settings.
7. Configure the network parameters for the system and each active network interface.
a. Use the Network Configuration table you prepared earlier.
b. When complete, return to the top menu.
8. When complete, select [OK] to leave Setup.
9. From command line, reboot the system: sudo /fss/bin/shutdown.pl --user admin --reboot
8. Fidelis Licensing — "Air Gap" and "No Feedback"
Installations
If your Fidelis Network products are deployed with "Air Gap" or "No Feedback" licenses, you must
install them with a license key. The CommandPost GUI shows the Host ID for the Fidelis Network
hardware, the current license key, and the expiration date. To access the License page:
1. Log into the CommandPost.
2. Click System / Components / Console / Config.
3. Click the License tab.
If your license key shows <no license> or <invalid>. Refer to Request a License for more
information.
©Fidelis Cybersecurity
Fidelis Network™ CommandPost Appliances
6
QUICK START GUIDE
www.fidelissecurity.com
Advertisement
Table of Contents
