FALCOM BOLERO40 SERIES Getting Started page 18

BOLERO40 Series Promotion Kit
Functions Configuration alarms and their descriptions.
into the GPRS network. This setting is provider-dependant.
$PFAL,CNF.Set,GPRS.APN=Public4.m2minternet.com
APN (Access Point Name) name that your network operator has provided to you to connect the device to
the GPRS/Internet. This setting is operator or provider dependant.
$PFAL,CNF.Set,GPRS.AUTOSTART=1
Enables automatic attachments to the GPRS network. If the GPRS network connection gets lost, it tries to
reconnect automatically as soon as the network is available again.
$PFAL,CNF.Set,GPRS.DIAL=ATD*99***1#
The V.250 'D' (Dial) command causes the device to enter the V.250 online data state.
$PFAL,CNF.Set,GPRS.QOS=0,0,0,0,0
Quality of Service Profile used when the device sends an Activate PDP Context Request message to the
GPRS network.
$PFAL,CNF.Set,GPRS.QOSMIN=0,0,0,0,0
Minimum acceptable profile checked by the device against the negotiated profile returned in the
Activate PDP Context Accept message.
$PFAL,CNF.Set,GPRS.TIMEOUT=1,600000
Detaches the device from GPRS network if no TCP communication available within the timeout.
$PFAL,CNF.Set,GSM.BALANCE.DIAL=*100#
GSM dial number for retrieving balance information
$PFAL,CNF.Set,GSM.OPLOST.RESTART=1,1200000,8
Reinitializes the GSM engine periodically until a GSM operator is found.
$PFAL,CNF.Set,PROT.3DP=0
3DP protocol (
the device.
$PFAL,CNF.Set,PROT.AREA=0
AREA protocol (
device.
$PFAL,CNF.Set,PROT.BIN=0
BIN protocol (FALCOM) is deactivated. To activate this protocol replace 0 to 1 and send it to the device.
$PFAL,CNF.Set,PROT.GGA=1
GGA protocol is activated. To deactivate this protocol replace 1 to 0 and send it to the device.
$PFAL,CNF.Set,PROT.GLL=1
GLL protocol is activated. To deactivate this protocol replace 1 to 0 and send it to the device.
$PFAL,CNF.Set,PROT.GSA=1
GSA protocol is activated. To deactivate this protocol replace 1 to 0 and send it to the device.
$PFAL,CNF.Set,PROT.GSM=1
GSM protocol is activated. To deactivate this protocol replace 1 to 0 and send it to the device.
$PFAL,CNF.Set,PROT.GSV=1
GSV protocol is activated. To deactivate this protocol replace 1 to 0 and send it to the device.
$PFAL,CNF.Set,PROT.IOP=1
This confidential document is a property of FALCOM GmbH and may not be copied or circulated without previous permission.
motion sensor data
) is deactivated. To activate this protocol replace 0 to 1 and send it to
area states
) is deactivated. To activate this protocol replace 0 to 1 and send it to the
Version 1.0.1
Page 17 of 21