Advertisement
brakes
g
stand behind buggy and with one foot push
brake down to activate; lift to deactivate.
note
always apply brakes when parking your
buggy. apply brake before loading children.
handle
at top of seat push down fabric to expose
top of frame. remove plastic bungs.
h
depress nib springs on handle and insert
it into holes at top of buggy frame until
it clicks into place.
i
handle can be removed, turned over and
reinserted for a higher handle height.
hood
j
Insert crimped wire ends into eyelets on
both sides of buggy frame.
k
attach snaps on back of sunhood to top
snaps on handle. attach snaps on front of
sunhood to side of buggy frame.
harness
l
unclip buckles on breastplate and place
baby in buggy. set upper strap height to
fit snugly over baby's shoulders. breast-
plate should fit snugly on baby's chest.
(you should be able to fit 2 average
sized fingers between straps and baby).
ups ` downs
there are 3 seat positions: upright, heads
up and newborn. adjust as required using
seat adjustment clips at rear of main seat.
m
upright: both clips are done up and top
webbing strap is as shown.
n
heads up: both clips are done up and top
webbing strap is as shown.
o
newborn: both clips are undone.
p
to return seat to upright position:
invert base and reattach clips.
plastic back flap
q
clear plastic back flap can be attached
to back of buggy to help protect your child
from poor weather. attach using velcro and
toggles as shown. back flap can be rolled
up and held at top using toggle under hood.
warning:
never allow plastic to fall over child.
baby ` toddler buggy
to use baby ` toddler position requires
purchase of double kit accessory. double kit
height can be adjusted by undoing snaps on
back of double kit frame, sliding down fabric
and reattaching to lower set of snaps.
r
double kit comes with hinges attached,
push in nib springs and insert into buggy,
once bungs are removed.
3
Advertisement
