Advertisement
classic instructions
assembling your new phil`teds inline
is effortless and fun. just follow these simple
steps and in 5 minutes you'll be off!
bits ` bobs
red numbers below refer to buggy parts
indicated inside back flap of this guide.
1.
rear guards
2.
rear wheels
3.
sun hood
4.
front wheel
5.
rear axles
6.
handle
7.
back flap
8.
footwell
9.
swivel lock
10.
harness
11.
fold lock
12.
auto frame lock
13.
wrist strap
14.
double kit (sold separately)
15.
retaining strap (comes with double kit)
safe ` sound
we've attained the following safety standards:
•
EN 1888:2005
•
AS/NZS 2088:2000
•
ASTM F833-07a
wheeling ` dealing
keep tyres inflated to 22PSI
classic
a
release fold lock by pushing in grey button.
TM
b
attach rear guards using a screw driver
as shown. screws located in housing.
c
insert axles into rear wheels (from
side without brake disk).
to attach rear wheels: depress black axle
hub and insert into buggy axle housing.
d
lift footwell as far as hinge will allow.
e
to attach front wheel: fully extend swivel
lock and insert wheel rod into buggy frame,
as shown. release swivel lock and check
wheel is in place for use.
to lock/unlock swivel wheel: extend and
rotate swivel lock, aligning silver pin with
hole in underside of swivel lock knob.
turn wheel towards rear of buggy (parallel
with rear wheels). lock will click into place.
to swivel, extend black swivel lock out and
rotate until knob rests on silver pin instead
of being inserted into hole.
gettin' it together
f
turn buggy over onto 3 wheels. pull up
until you hear a resounding 'click'. ensure
that auto frame locks are engaged.
note
double seat as you may damage hinges.
2
for double buggy do not lift frame using
Advertisement
