Table of Contents
Advertisement
A
ssembling your Flip-Ease
Assembling your new Flip-Ease is a 3
Step Process, requiring no tools.
1.
Insert foot into body of unit until you hear
a click.
2.
Place the Solution Tube onto the spray
connector.
3.
Insert the handle into the body of the unit.
Turn handle until key in handle falls into
position until you hear a "click".
Charging
Note: The unit will come partially charged.
Charge completely before using 12 hours
or overnight.
Average run time for Dry Vacuuming is
12 minutes.
A.
To charge, place the charger plug into the
Charging Port on the side of the unit. Make
sure it is in securely and the charge
indicator light is illuminated. Make sure
power switch is in the "off" position.
Filling the Clean Tank
1.
Remove tank from the unit.
2.
Unscrew the black cap on the bottom of the
solution tank and remove the insert.
3.
Fill with Tap Water to the full line and fill the
remainder with BISSELL formula. Replace
the cap and insert assembly. Place the full
tank back into the unit.
w w w . b i s s e l l . c o m
ug603-6913_5288_606.indd 5
ug603-6913_5288_606.indd 5
1
2
3
A
Tip:
You will only
utilize battery
charge while dry
vacuuming. For
wet mopping, the
batteries are not
used, extending
usage time.
1
2
8 0 0 . 2 3 7 . 7 6 9 1
Charger
Plug
Tip:
Gently push the
tank into place. If
you see air
bubbles in the
tank, it is
seated properly.
FORMULA
5
6/20/06 9:12:25 AM
6/20/06 9:12:25 AM
Advertisement
Table of Contents
