To Turn On Appliance; To Turn Off Appliance; Flame Height Adjustment - Maxitrol Mertik GV60 Operating Instructions Manual

OPERATING INSTRUCTIONS

TO TURN ON APPLIANCE

When pilot ignition is confirmed, motor turns automatically
to maximum flame height.
▪ Turn MANUAL knob on valve to the ON, full counter-clock-
wise position (see figure 27, page 19).
▪ Place ON/OFF switch (if equipped) in I (ON position).
Handset
▪ Simultaneously press the OFF and
flame) buttons until a short beep confirms
the start sequence has begun; release but-
tons.
▪ Continuing beeps confirm the ignition is in
process.
▪ Once pilot ignition is confirmed, there is
main gas flow.
▪ After main burner ignition the handset will
automatically go into manual mode (CSA
version, CE version).
Wall Switch / Touchpad / Switch Panel
▪ Press button "B" (see figure 25) until a short beep confirms
the start sequence has begun; release button.
▪ Continuing beeps confirm the ignition is in process.
▪ Once pilot ignition is confirmed, there is main gas flow.
If the pilot does not stay lit after several tries, turn the main
valve knob to OFF and follow the instructions "TURN OFF
GAS TO APPLIANCE" (page 19).
STANDBY MODE (Pilot Flame)
Handset
▪ Press and hold (small flame) to set appliance at pilot flame.
Wall Switch / Touchpad / Switch Panel
▪ Press and hold button "C" (see figure 25) to set appliance
at pilot flame.
A) Increase flame height
B) ON/OFF
C) Decrease flame height
Figure 25: Switch Panel and Wall Switch/Touchpad

TO TURN OFF APPLIANCE

FLAME HEIGHT ADJUSTMENT

(large
Handset
Wall Switch/Touchpad/Switch Panel (see figure 25)
▪ Press and hold button "A" to increase flame height.
▪ Press and hold button "C" to decrease flame height or to
set appliance at pilot flame.
▪ For fine adjustment tap button "A" or "C".
Designated Low Fire and High Fire
C
MAN
C
MAN
If the appliance will not operate, follow the instructions
"TURN OFF GAS TO APPLIANCE" (page 19).
15 / 20
FOR OEM USE ONLY
Handset
▪ Press OFF button.
Wall Switch / Touchpad / Switch Panel
▪ Press button "B" (see figure 25).
▪ In standby mode: Press and hold
flame) button to increase flame height.
▪ Press and hold (small flame) button to de-
crease flame height or to set appliance at
pilot flame.
▪ For fine adjustment tap the
or (small flame) buttons.
▪ Double-click (small flame) button. "LO"
will be displayed.
NOTE: Flame goes to high fire first before
going to designated low fire.
▪ Double-click (large flame) button. Flame
automatically goes to high fire. "HI" will be
displayed.
(large
(large flame)