Pairing Instructions - Task Lighting T-C-RGB180 Installation Manual

Step 2: Pairing Receiver to Controller
1.
Remove Controller from back plate,
slide battery compartment open, remove
battery, and discard clear plastic tab.
Reinsert battery, replace cover.
Step 2: Setting the Controller buttons
1.
Press the COLOR button on the
Wireless Controller to rotate through the
colors, one by one. Alternatively, press
and hold the COLOR button to scroll
through colors. Release button when
desired color is reached.
4.
Press the BRIGHTNESS button ( ) and
hold to dim or brighten the lights.
Customer Service: 800.445.6404 • Design Services/Technical Support: 866.848.9094 • TaskLighting.com
40

Pairing Instructions

2.
Clear the receiver by pressing and
holding the Learning button until the lights
blink twice
2.
To save a color, press and hold the M1
button until the lights flash. Continue the
same procedure with M2, M3, and M4
buttons.
3.
Quickly press and release the
Learning button and, within 5 seconds,
press and release one of the 4-Zone
buttons on the Controller. When lights
blink once, Controller and Receiver are
paired.
3.
Press the ( | ) PLAY button to set a fade
mode. Press again to pause.