Table of Contents
Advertisement
42 SBC622 Hardware Reference Manual
2.1.9 Quad GbE Ports via the Front Panel and Backplane
The SBC622 supports four Ethernet LANs with four Intel Ethernet controllers
provided by the Intel 82580.
Front panel or backplane selection of the GbE port is made by the onboard
jumper, E7 at points 5‐6; 10Base‐T, 100Base‐TX and 1000Base‐T options are
supported via a front panel RJ45 connector or selectable to the backplane by
routing to P4 per Open VPX and VITA 46.7.
• Front Panel selection of the GbE port includes two status LEDs displaying
speed and link activity on the RJ45 receptacle
• Backplane selection of the GbE port provides no LED support
• Ports 1 and 2 provide 10/100/1000‐T support and routed to P4 (one channel
mux'd with the Front Panel)
• Ports 3 and 4 provide 10/100/1000‐BX support and routed to P4
GbE ports support remote boot from either the Front or Rear configuration.
2.1.10 Dual 10 GbE
The SBC622 supports Dual 10 GbE Ports 1 and 2 that are controlled by the Intel
82599 Ethernet Controller.
• Dual 10 GbE (1000BASE‐KX4) is routed to P1.
2.1.11 Remote Boot BIOS
The SBC622 supports remote booting on the GbE Quad ports 1‐4 and Dual 10 GbE
ports 1‐2 using the Intel PXE Boot firmware Ethernet BIOS firmware. Refer to
Section 3.3 Remote Ethernet Booting on page 64.
Advertisement
Table of Contents
Need help?
Do you have a question about the OpenVPX VPXcel6 SBC622 and is the answer not in the manual?
Questions and answers